English
Русско
Deutsch
Español
Português
Français
Türk
Italiano
Nederlands
हिन्दी
Bahasa Indonesia
Lamp Motion Sensor
| Item No.: | pir-607 |
Supplier Details
Country: Taiwan
City: Taichung
Address: Taichung Industrial Area
TEL: +886-4-1234567
Fax: +886-4-1234567
Online Showroom:
31 Products
1.Functions & Characteristics:
- Our PIR-607 has the patented design for overheat protection. If the temperature of the downlight is over 100 degree C, the light will be turned off for the safety features. After the temperature of the downlight is reduced to about 40 degree C, the PIR-607 sensor will start its function again.
- D.I.Y. design – Fire resistant material used,high-temperature resistance ,blaze resistance and flash resistance.
- It has CDs, the sensor will only turn on the lights at night.
- Dual sensor can work independently with high performance. It is suitable for stairs or special ground.
- Suitable for any screw lampshade or lamp holder.
- With Japan JET and CE Markings.
- Application places: Hallway, door gate, office building, conference hall & etc.
2.Specification:
Model No. | PIR-607 Downlight Dual Lamp Sensor |
Power Supply | AC110/240V 50/60HZ |
Max. Load | Incandescent lamp: 60W, energy saving lamp:23W and LED |
Power Consumption | standby: <1.3 W |
Sensing Angle | R&L:<130°, UP&DOWN:<90° (at 25°C) |
Sensing Distance | 25℃<8m |
Illumination | Under 3LUX: sensor is active, over 30LUX: sensor not active |
Off Delay time | 1:10 sec. (night), 2:90 sec. (night), 3:330 sec. (night) |
Warm-up Procedure | Install at daytime: the lamp will flash 3 times after energized. Install at nighttime: the lamp will light for about 20 seconds then automatically shut off after energized. |
Dimension | 5.6×5×7cm |
Weight | 110g |
Wiring | Rotating socket ( Screw-in Pin) |
3.Instructions:
- Turn off the power and take off original screw bulb and then put bulb into PIR-607. Finally, install them into the lamp holder and pull the sensor line to adjust the sensing angle.
- Install at daytime: the lamp will flash 3 times after energized. Install at nighttime: the lamp will light for about 20 seconds then
- automatically shut off after energized.
- After installation,Under 3LUX: sensor is active, over 30LUX: sensor not active
- Off delay time: 1:10 sec. (night), 2:90 sec. (night), 3:330 sec. (night)
4.Sensing Range and Distance(At 25°C)
WIREFRAME_
5.Patent & Certificate:
PATENT_